Series AG Angular Contact Bearing | GMN Bearing USA

Series AG Angular Contact Bearing

Series AGThe GMN +AG series is designed for direct grease lubrication through the outer race on the non-load side. The +AG series is GMN’s response to the increased popularity of direct grease lubrication for extreme maintenance cycle requirements. Specific +AG characteristics are:

  • Optimized for maximum speeds - speed factor n*dm up to 2.3 • 106mm/min)
  • Maximum service life - up to factor 10
  • Reduced overhead cost for grease re-lubrications
  • High operating efficiency
  • Low capital expenditure
  • Designation example: HY SMAG 6005 CTA A7 UL
  • Hybrid (Silicon Nitride balls) available upon request

Click here or call 1.800.323.5725 to Request a quote

Back to Top